Solenoid Valves
Description
Symbol
Cross Section
Cavity Details
338
SAE08
Technical Features
All external surfaces are zinc plated and corrosion-pro-
of. All valve parts are made of high strength steel. Pop-
pet is hardened and ground to ensure minimal wear and
extended service life. Coil seals protect the solenoid
system. Manual override option.Industry SAE common
cavity. It replaces the previous SVN0.S08.
SVJ0.S08 Valve Series
SAE Cartridge - 350 bar
NO Single Lock Pilot Operated
Poppet Type
Solenoid operated, 2-way 2-positions, normally open,
piloted poppet type, screw-in cartridge valve. Typically
used as a blocking or load holding device for high pres-
sure circuits. When the coil is de-energized, the SVJ0.
S08 allows flow from 2 to 1, while flow from 1 to 2 is
severely restricted. When the coil is energized the val-
ve closes, blocking flow from 2 to 1. In this mode, flow
from 1 to 2 is allowed once the pressure overcomes the
force of the solenoid. The rigid design using a 1-piece
body contributes to minimize the effect of eccentrici-
ties in cavity and provides great reliability. Low pressure
drop thanks to optimized flow path.
( )
Specications may change without notice.
339
Ordering Code
Performance Details
Flow (l/min)
Pressure (bar)
Technical Data
Note: The performan-
ce chart illustrates flow
handling capacity 2 to 1
(de-energized).
p/Q curves are recorded at
TOil = 40°C and 46 cSt.
Maximum operating pressure 350 bar
Maximum flow 40 l/min
Maximum internal leakage 0,25 cm
3
/ min @ 350 bar
External component treatment
Zn/Fe - standard (96h)
Zn/Ni (720h)
Switch ON Time 100 ms
Switch OFF Time 50 ms
O-ring Temperature Range -30° C to 110° C (standard sealing NBR - BUNA-N)
Oil Temperature Range -30° C to 110° C
Fluids Mineral - based or synthetics with lubricating properties
Viscosities 7,4 to 420 cSt
Minimum pull-in voltage 85% of nominal
Filtration 20/18/15 ISO 4406 (maximum ltration admitted)
Orientation No restrictions
Installation torque 40 - 45 Nm (Hex. 24)
Technical Specications for characterization see page 480
Oil testing condition ISO VG 46 cSt
Seal kit code SK.030 and SK.027 (coil)
Coil 18W (for more detalis see page 410-425)
Weight 0,124 kg
NOTE: for more details see page 426-427.
Note: All Solenoid cartridge valves listed in the present catalogue are desi-
gned to work with D.C. power supply. To work with A.C. power supply, a RAC
coil and connector with rectier must be used. For any additional informa-
tion, please contact your Sales contact representative.
